Internals

Internal view just before gluing the back on. Acoustic wool will be stapled across the centre later.

The usual double thickness front was discounted due to the slim design. Instead, the area behind the driver was strengthened. Blocks were fitted where the grille clips are installed, giving the required depth of timber.

The port intakes were supported by small panels which allowed the routing of flares, and double as braces

A ring was added to the tube at the top of the photo. The tube is to give access to fit a bolt to hold the speaker against the wall. The ring, when glued to the back panel, will provide extra strength and an airtight seal.

The step in the edge bracing is where the back panel clears the skirting board when placed against the wall